Kenwood Chef A901 Opknappen – Reparatie

IMG_7060 keukenmachineVersnellingsbak Schoonmaken

Wat heb je nodig:
Steeksleutels 10 en 15
Kruiskop schroevendraaier
Grote platte schroevendraaier
Tang met platte bek
Foodgrade Grease van Kenwood
Siliconenkit
3L Spiritus
Keukenpapier of oude T-shirts
Fotocamera

Begin met het los schroeven van de drie schroeven aan de achterkant van de machine waar de blender op gezet word.
Verwijderde de plastic kapjes aan de voorkant van de machine bij de vleesmolen ingang en bij de citruspers ingang.
Nu kan je de kap afnemen. Hieronder de originele Engelse Tekst met instructies om het vet bij te vullen of te vervangen.
Ik kan je wel aanraden om origineel vet te gebruiken, het is wat duurder maar is er wel speciaal voor gemaakt.
Maak foto’s of aantekeningen zodat je weet hoe het weer in elkaar moet.

Word vervolgd met meer tekst, vertaling en uitleg, hiermee kan je al een eind komen natuurlijk, dit zijn alleen mijn aantekeningen tot nu toe…
*******

A901UNPLUG YOUR MIXER FROM THE ELECTRICITY.

MIXER ACCESS – see also Drive Belt below.

GEARBOX – GREASE TOP UP
In order to top up the gearbox you must remove the two screws securing the plastic planet hub underside cover.
The gearbox top up point can be found on the base of the gearbox, the planet hub surround and drip mat needs to be removed to gain access.
The Top Medium outlet is a grease overflow as well as the drive outlet for the citrus juicer, this hole must be kept clean, grease can be wiped out with a cloth.

GEARBOX – GREASE REPLACEMENTKenwood chef A901 grease top upKenwood chef A901
In order to dismantle the gearbox you must remove the six screws securing the top cover. To remove the large pulley you must lock the slow speed outlet and turn it anti clockwise. To lock the Slow speed drive insert your mincer attachment into the gearbox, or use a large screwdriver inserted into the drive key.

When open, clean out the gearbox, gears and sealing faces, Methylated spirit is used to clean the gearbox. Reassemble by adding half the grease, add the gears, add the rest of the grease. Apply a thin even coat of silicone / silastic sealant to the body jointing face of the gearbox. Additional grease can be added using the filler cap screw underside the gearbox.

Silicone seal is used to reseal the faces on completion.

 

GREASE FOR THE PLANET HUB.
First you must remove the central nut on the old planet hub and gently wiggle the hub by pulling downwards whilst turning, it should eventually come off. Be prepared to catch it and protect the paintwork below with a cloth. (You can leave the nut on the last few threads if you wish to stop the hub falling off completely until you have loosened the hub to come off, then remove the nut and hub altogether.)

Ensure both the Planet Hub gear and the Ring Gear has a ‘finger’ of grease for lubrication. You must apply grease to the teeth parts on both.

DRIVE BELT
To access the belt you must remove all outlet covers Front Slow speed, Rear High speed and Citrus cap (if applicable).

Remove the three screws from the high speed spigot (note its positioning / orientation), then remove the top gearbox housing by lifting it up and sliding it forwards.

Remove the drive belt by sliding it upwards whist turning the gear wheel to help it off.

*******


Zo rauw klinkt de machine nu nog…